Setting the Sleep Timer | Philips CCA132AT instruction

46 Setting the Sleep Timer

Use the sleep timer to program the TV/VCR to shut off in a cer- tain amount of time.

1

Press the SLEEP button. The sleep timer display will appear on-screen. (You can not set the sleep timer during a recording.)

SLEEP 0 MIN

2

Within five seconds, press the SLEEP button repeatedly to select 30 minutes, 60 minutes, 90 minutes, or 120 min- utes. In a few seconds, the display will disappear. Then the TV/VCR will shut itself off after the specified amount of time. One minute before the TV/VCR shuts itself off, the seconds will count down on-screen.

GOOD NIGHT appears on the TV/VCR screen 10 seconds before the TV/VCR shuts itself off.

SLEEP 10 SEC

GOOD NIGHT

●To see how much time remains until the TV/VCR shuts itself off, press the SLEEP button once. The time remaining will appear on-screen briefly. You cannot do this during a recording.

●To cancel a sleep timer setting, press the SLEEP button until 0 MIN appears on-screen. The on-screen display will disappear in a few seconds. You cannot cancel the sleep timer during a recording.

1-2

POWER

SLEEP

	PLAY
REW		F.FWD
	STOP
MENU	STATUS/EXIT	CLEAR

1	2	3
4	5	6	CH.
4	5	6
7	8	9
	0	ALT. CH	VOL.
	0	ALT. CH
SPEED	MEMORY	PAUSE/STILL
REC/OTR	TRACKING		MUTE

Helpful Hints

•Finish all recordings before the TV/VCR shuts itself off. If a record- ing is in progress, the sleep timer will be cancelled.

•A timer recording will not begin unless the TV/VCR power is off. Two minutes before a timer record- ing starts, PLEASE TURN OFF FOR TIMER RECORDING flashes on- screen. If you see this message, turn off the TV/VCR.

•If the power fails, you might lose

the sleep timer setting.

Image 46

Philips CCA132AT owner manual Setting the Sleep Timer, If the power fails, you might lose Sleep timer setting

Contents

CCA132AT Dear Philips Magnavox product owner For Customer Use Introduction FeaturesSafety Precautions Philips Consumer Electronics Company recommends that Table of Contents TV/VCR Maintenance Putting Batteries in the Remote ControlUsing the Remote Control Erasure Prevention Hooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownRod Antenna Hooking Up the TV/VCR cont’d Crooked Pin Straight Pin Turning On the TV/VCR You cannot set up channels if you are using a Cable BoxTons to select another channel Press the Menu button Press the STATUS/EXIT button Automatic Channel Setup Press the PLAY/ o button or the STOP/ p button to select Adding/Deleting ChannelsPress the STATUS/EXIT button once or twice Manual Clock Setting Setting the ClockCable Box users must set the clock manually Setting the Clock cont’d Setting the Clock cont’d Automatic PBS Channel Selection Wait for the TV/VCR to find the time Manual PBS Channel Selection Press the PLAY/ button or the STOP/ button to Select SET PBS CH. MANUAL. Then, press the F.FWD/B Daylight-Savings Time Time Zone Front Panel Rear Panel AC Power CordANTenna Jack Remote Control Buttons STATUS/EXIT Button STOP/ ButtonREWind/ Button Menu Button Adjusting the Picture Controls More brilliant Adjusting the Picture Controls cont’dDecrease Increase Softer If you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFF Press the PLAY/ button or the STOP/ button to select Reminder Playing Recording options are on pages RecordingGiven below Distortion may appear on the tape One-Touch Recording Different brands of equipment may operate differently Rerecording Tape DuplicationAudio and video cables are not included Timer Recording Daily Timer Recording cont’d Rect information Timer Recording cont’d Checking or Clearing Timer Recordings With the TV/VCR on, press the Menu button Defeat Recording Repeat Play B Repeat Play Insert a tape in the TV/VCR Press the Menu button Repeat Play cont’d Press the STATUS/EXIT button to remove the display. a Real-Time Counter Memory Press the STATUS/EXIT button. The real-time counter will Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still Picture SmartLock SmartLock cont’d Example Specific Ratings To change the access code, follow these steps Blue Background Ground Setting the Sleep Timer If the power fails, you might lose Sleep timer setting Volume Bar Menu Closed CaptionExample Screen May be delayed for a few seconds Closed Caption cont’d Automatic Operation Features Specifications Glossary Helpful Hints Helpful Hints cont’d Limited Warranty TV/VCR Combination Channel Above Adding Deleting Reviewing Setup Buttons Index Supplied Accessories