Philips CCW135AT, CCZ132AT owner manual Turning On the TV/VCR, Screen shown below will appear

Before you turn on the TV/VCR, make sure there are batteries in the remote control and the TV/VCR is hooked up correctly.

The instructions on this page work only when you turn on the TV/VCR for the first time.

1

Press the POWER button. The TV/VCR will come on and the

Turning On the TV/VCR 9

1	POWER	SLEEP
		ALT.CH

1 2 3

4 5 6 o

screen shown below will appear.

SELECT LANGUAGE

> ENGLISH ON

ESPAÑOL

SELECT KL OR

PRESS MENU TO CONTINUE

2

78

0

	SPEED
o	REW

CHANNEL

9p

+100 o

MUTE VOLUME

p

o

PLAY

F.FWD o

STOP

p

5

4

2

Press the PLAY/K button or the STOP/L button to select

English or Spanish on-screen displays.

3

Press the MENU button. The screen shown below will appear.

CONNECT ANTENNA OR CABLE

TO TVCR

THEN PRESS B

TO END PRESS EXIT

REC/OTR	MEMORY	PAUSE/STILL
			o
MENU	STATUS/EXIT	CLEAR	TRACKING

3 p

4

Press the F.FWD/B button to begin automatic channel setup. The TV/VCR will memorize all available channels. When channels are set, CHANNELS ARE SET will appear on-screen briefly. Then the TV/VCR will go to the lowest channel pro- grammed.

(If you try to set up channels when there is no antenna or cable connected to the TV/VCR, programming will appear to take place, but eventually a NO TV SIGNALS ... message will appear on- screen. Connect an antenna or cable to the TV/VCR, then try again. You may need to follow the steps on page 11 instead.)

5

Use the CHANNEL o/p buttons or the Number buttons on the remote control to select a TV/VCR channel. Use the VOLUME o/pbuttons to adjust the sound.

Helpful Hints

•If you do not see any on-screen dis- plays when you turn on the TV/VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps on pages 10 - 11 to select a language and set up channels.

•To skip step 2, press the STATUS/EXIT button. All on-screen displays will be in English. To skip step 4, press the STATUS/EXIT but- ton. Channels will not be set up, and CHANNELS NOT SET will appear on-screen briefly.

•You cannot set up channels if you are using a Cable Box.

•Line Input mode will always be stored in the TV/VCR’s memory as channel 00. When you select chan- nel 00, A/V IN will appear on- screen briefly. Press the CHANNEL o/p buttons or Number buttons to select another channel.