Mount into the dashboard

1 If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery.

	• If you disconnect the car battery in
	a car that has an on-board drive or
	navigation computer, the computer
	may lose its memory.
	• If the car battery is not disconnected,
	to avoid short-circuit, make sure that
	the bare wires do not touch each
2	other.
2	Make sure that car dashboard opening is
	within these measurements:
	5mm
	183
	mm
	53mm

3 Install the sleeve into the dashboard and bend the tabs outward to fix the sleeve.

Note

•• If the system is not fixed by sleeve but by the supplied screws, skip this step.

E n g l i s h

		53
		.
		5
	183	mm
	183	mm
		mm

4 Place the supplied rubber cushion over the end of the mounting bolt.

5 Slide the system into the dashboard until you hear a "click".

EN 11

Page 10

Image 10

Philips CMD310 user manual Mount into the dashboard

Contents

ES-AR Contents Compliance SafetyCare of the environment Trademark notice Copyright Introduction Check and identify the contents of the packageYour car audio system Whats in the box Overview of the system Utsr q C d Ghi Reset Connect to a USB storage device Before use Install the car audio systemConnect wires Yellow Car first Red wire +12V power terminalCar battery terminal that is Green Left speaker rear Mount into the dashboard Turn on Change system settingsGet started Set the clock Select a source Listen to radioTune to a radio station Select a tuner sensitivity Tune to a preset stationStore radio stations in memory Store stations automatically Make a call During play, follow the instructions below to control play Enable or disable shuffle playControl play Pause or resume play Skip to the previous or next track Prepare for docking Use the dockCompatible iPod/iPhone models An application CarStudio is available Load your iPhone or iPod touch Switch to landscape mode Adjust the dock bracketPair your iPhone via Bluetooth Switch to portrait mode Charge your iPhone or iPod touch Enjoy audio through the dockUse the CarStudio application Undock your iPhone or iPod touch Flip the dock bracket downwards until you hear a click Store the dock bracketPull out your iPhone or iPod touch Push the dock panel inwards until you hear a click Adjust sound Other sound settings Additional information Reset the systemYou can reset the system to factory default settings Replace the fuse Product information No power or no sound TroubleshootingAbout Bluetooth device General Paired mobile phone connects and disconnects constantly GlossaryWMA Windows Media Audio Sistema DE Audio Para Automovil Modelo CMD310/55

Mount into the dashboard

may lose its memory.

183