Philips CRA01/00 manual Loop-Through Card I/O Interfaces, Installation Instructions

D. Loop-Through Card I/O Interfaces

2

32-pin connector

3

1654

	Connector	Application
1	15-pin D-SUB Female	VGA Out (Local)
2	15-pin D-SUB Female (High Rise)	VGA In
3	15-pin D-SUB Female (High Rise)	VGA Out (External)
4	9-pin D-SUB Male	RS232 Out (External)
5	9-pin D-SUB Male	RS232 In
6	9-pin D-SUB Female	RS232 Out (Local)

E. Installation Instructions

1.Turn off the power to your Philips monitor and disconnect the power cable.

2.Place monitor face-down on a clean, non-abrasive surface.

3.Locate the SmartCard slot opening on the rear of the display. (see Fig. 2 below)

SmartCard Slot Cap

Page 3 of 9 LT Installation Guide 1.1 (140907) 12NC: 3139 125 39281