Basic Functions
English
IMPORTANT!
–Make sure to complete the preparation procedures before operating the system.
Switching the system on
●Press POWER.
➜The system will switch to the last selected source.
●Press SOURCE on the set or iPod, TUNER, USB/CARD or AUX on the remote control.
➜The system will switch to the selected source.
Switching the system to standby mode
●Press POWER.
➜ The backlight for clock display is off in standby.
➜The display displays clock time, or
➜The volume level (up to a maximum volume level of 12), interactive sound settings, last selected mode (ECO Power Standby or normal standby), source and tuner presets will be retained in the player's memory.
Switching the system to Eco Power Standby mode
●Press and hold POWER for more than 2 seconds.
➜ The backlight will go blank.
Power Saving Automatic Standby
As a
Adjusting volume and sound
1Press VOLUME +/- on the system (or VOL +/- on the remote control) to decrease or increase the volume.
➜ Display shows the volume level VOL and a number from 0, 1, 2, ...32.
2In USB/Tuner mode, press and hold DSC on the set, then release to select a sound effect: ROCK/
POP/JAZZ/CLASSIC.
●In iPod /AUX mode, simply press DSC on the set to select the desired sound effect.
3In USB/Tuner mode, press and hold DBB on the set, then release to switch bass enhancement on
or off.
●In iPod /AUX mode, simply press DBB on the set to switch bass enhancement on or off.
➜If the DBB is activated, DBB ON is shown.
➜If the DBB is deactivated, DBB OFF is shown.
4Press MUTE on the remote control to interrupt sound reproduction instantly.
➜ Playback will continue without sound and MUTE will flash on the display.
●To activate sound reproduction you can:
–press MUTE on the remote control again;
–adjust the volume controls;
–change source.
14
