Philips DVD740VR owner manual Signal Cable, TV’s Antenna

DVD740VR 4/12/02 12:08 PM Page 10

10 Hookups (cont’d)

DVD/VCR to Cable Box/DBS (Satellite Receiver) and TV

Using only basic RF coaxial cables

This connection will let you use the features of both the VCR and the DVD Player.

1 DVD/VCR

ANT-IN

ANT-OUT

CH3 CH4

Cable

	DVD/VCR		Cable Box/DBS
		COMPONENT
	2IN OUT DVD/VCRVIDEO OUT
L	AUDIO OUT		Y	DIGITAL AUDIO OUT
AUDIO			S-VIDEO
R		L		PCM / BITSTREAM
	IN		Cr OUT	COAXIAL OPTICAL
VIDEO		R	Cb	OUT

RF coaxial

75
AN
C	T /
ABLE

Signal	cable
RF coaxial	3	TV’s ANTENNA
		IN Jack
cable
Connections

1 Connect a Cable signal to the DVD/VCR’s ANT-IN (Antenna In) Jack.

2 Use an RF coaxial cable (as the one supplied) to connect the ANT- OUT (Antenna Out) Jack on the DVD/VCR to the IN Jack on the Cable Box/DBS.

3 Use a second RF coaxial cable to connect the OUT Jack on the Cable Box/DBS to the ANTENNA IN Jack on the TV.

Remember...

There are two ways to connect your Cable Box/DBS to the DVD/VCR. With the connection on this page:

●You may watch one channel while recording another. Follow these steps:

1)Put the Cable Box/DBS on the same channel as the DVD/VCR’s CH3/CH4 switch. Set the TV to the Cable Box/DBS output channel (03 or 04).

2)Press OUTPUT SELECT to put the DVD/VCR in VCR mode. The green VIDEO light will appear on the front of the DVD/VCR. Then, press the VCR button, then press VCR/TV to choose VCR position. The green VCR/TV light will appear on the front of the DVD/VCR

3)Press CHANNEL/SKIP j/i (p/o) to select the channel you want to record at the DVD/VCR. Start the recording.

4)Press the VCR/TV button once to put the DVD/VCR in TV position. The VCR/TV light will go off.

5)Select the channel you want to watch at the Cable Box/DBS.

●When you play a tape or Disc, make sure the Cable Box/DBS is set to the same channel as the CH3/CH4 switch on the DVD/VCR. Set the TV to the Cable Box/DBS output channel (03 or 04).