Getting Started
Step 1: Inserting batteries into the Remote Control
3
1
2
1 Open the battery compartment.
2Insert two batteries type R06 or AA, following the indications
3 Replace the cover.
Using the Remote Control to operate the Player
1 Aim the Remote Control
directly at the remote sensor (iR) on the front panel of the DVD Player.
2 Do not put any objects between the Remote Control and the DVD Player while operating the DVD Player.
PREVIEW MUTE
CAUTION!
–Remove batteries if they are exhausted or if the Remote Control will not be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed properly.
Step 2: Setting up the TV
IMPORTANT!
Make sure you have completed all the necessary connections. (See pages
1Turn on the TV and set it to the correct
2 Usually these channels are between the lowest and highest channels and may be called FRONT,A/V IN, or VIDEO. See your TV manual for more details.
➜Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.
➜Or, the TV Remote Control may have a button or switch that chooses different video modes.
➜Or, set the TV to channel 3 or 4 if you are using an RF modulator.
3 If you are using other external equipment (audio system or receiver), turn it on and select the appropriate input source for the DVD Player. Refer to the equipment owner’s manual for details.
Deactivate Progressive Scan manually
The progressive scan display presents 60 complete frames per second, rather than 30 frames per second of interlaced scanning (normal TV system).With nearly double the number of lines, progressive scan offers higher picture resolution and eliminates bothersome motion artifacts jagged edges on moving objects.
To enjoy the quality offered by progressive scan, a progressive scan TV is required.To activate progressive scan, refer to ‘Progressive’ on page 30.
