13 | OPERATING THE SYSTEM |
™The last preset radio station will appear on the display when PLUG and PLAY is completed.
•To exit without storing the PLUG and PLAY, press Ç button (on the
system only).
Notes:
– | PLUG and PLAY will be reinitiated |
| again during the next power up if : |
| i) PLUG and PLAY installation was not |
| completed. |
| ii) No stereo frequency being detected |
| during PLUG and PLAY, "CHECK |
| ANTENNA" will be displayed. |
– | You can store any radio stations |
Demonstration mode
The system has a demonstration mode that shows the various features offered by the system.
To disable the demonstration mode
•Press and hold Ç (on the system only) for five seconds when the system is in demonstration mode.
™"DEMO OFF" is displayed.
™The system will switch to standby mode.
To enable the demonstration mode
Switching the system ON
•Press CD, TUNER, TAPE or AUX.
•Press
You can also switch on the system by pressing any one of the CD DIRECT PLAY buttons (on the system only).
Switching the system to standby mode
•Press
™The system will switch to standby mode.
DIM mode
You can select the desired brightness for the display.
•Press DIM to select DIM 1, DIM 2, DIM 3 or DIM OFF display mode.
™The DIM display lights up.
™"DIM 1", "DIM 2", "DIM 3" or "DIM OFF" will be displayed depending on the mode selected.
DIM OFF - normal brightness with Spectrum Analyzer On
manually or automatically after PLUG |
and PLAY. |
– When PLUG and PLAY is used, all |
previously stored radio stations will be |
replaced. |
– During PLUG and PLAY, if no button is |
pressed within 15 seconds, the system |
will go to demonstration mode (if |
demonstration mode is enable) |
•Press and hold Ç (on the system only) for five seconds when the system is in standby mode.
™ The demonstration will begin.
Notes:
–If the demonstration mode has not been disabled, it will resume five seconds later after the system switches to standby mode.
–When the system is switched on from the main power outlet, the CD changer tray may open and close again to initialize the set.
–Even though the AC power cord is removed from and reconnected to the wall socket, the demonstration will remain off until it is switched on again.
Selecting the Source
•Press the respective source selection button: CD, TUNER, TAPE or AUX.
™The display indicates the selected source.
Note:
–For an external source, make sure you have connected the audio left and right OUT terminals of the external equipment (TV,VCR, Laser Disc player, DVD player or CD Recorder) to the AUX IN terminals.
DIM 1 - normal brightness with Spectrum Analyzer Off
DIM 2 - half brightness with Spectrum Analyzer On
pg | 13 | 12/6/00, 2:20 PM | 3139 115 20353 (ENG) |