Preparations
IMPORTANT!
–Make sure to complete the preparation procedures before operating the system.
Step 1: Inserting batteries into the remote control
3
1
2
1Open the battery compartment.
2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as
indicated by “+” and
3Close the cover.
Using the remote control to operate the system
1 Point the remote control directly at the remote sensor (iR) on the front panel.
2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example TAPE,TUNER).
3Then select the desired function (for example 2;, 4, ¢).
CAUTION!
–Remove batteries if they are exhausted or will not be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed of properly.
Step 2: Setting the clock
The clock can be set in either
1Go into Standby mode.
➜If you have not set the clock,
2Press CLOCK and “00:00” blinks on the display.
➜The current time is flashing on the display.
➜If you have not set the clock,
3Press O or P on the system to set the hours.
4Press 5 or 6 on the system to set the minutes.
5Press CLOCK to confirm your setting, and then go into standby mode.The system will store the setting automatically.
➜The time setting becomes effective.
To exit the setting without storing
●Press 9 on the system to exit.
➜“CANCEL” will appear on the display.
●Press ECO POWER to exit setting mode and go into ECO POWER mode.
●You can also press DISC, DISC1~3, DISC CHANGE, OPEN/CLOSE to exit setting mode and go into disc mode.
●The system will also exit setting mode and go to tuner, AUX, tape mode wheh you press the corresponding source button.
Viewing the clock
●In Standby mode, Press DISPLAY on the system to toggle between
➜The time will be displayed.
Notes:
–The clock will be cancelled when the power cord is disconnected or if a power failure occurs.
–During clock setting, if no button is pressed within 30 seconds, the system will exit the setting mode and go into standby mode.
English
19