Trimming Nose Hair
◗Make sure nasal passages are clean.
1Place nose, ear and eyebrow attachment on Groomer.
2Switch the Groomer on and insert the tip of the attachment into one nostril (fig. 14).
CAUTION: Do Not insert the tip more than 3/16 in./5mm into your nostril.
3Slowly move the tip in and out while turning it around at the same time in order to remove unwanted hair. For best results, make sure the side of the tip is firm against skin. This will reduce the tickling effect that can occur during trimming of nose hair.
4Turn off Groomer. Rinse attachment clean after each use.
Trimming Ear Hair
◗Clean outer area of ear and ear canal. Make sure it is free of wax.
◗Nose, ear and eyebrow attachment should be on the Groomer.
1Switch the Groomer on and move the tip softly around the edge of ear to remove hairs extending beyond the outer ear (fig. 15).
2Carefully insert the tip into outer ear canal.
CAUTION: Do not insert the tip further than 3/16 in./5mm into the ear as this could cause damage to the eardrum (fig. 16).
3Turn off Groomer. Rinse attachment clean after each use.
Trimming Eyebrow
◗Nose, ear and eyebrow attachment should be on Groomer.
1Switch the Groomer on and use the tip to
cut individual eyebrow hairs.
The Groomer can be used for clipping single long hairs.
2Put the Groomer at the root of the hair and move it along the edge of the eyebrow from the base of the nose towards the outer tip of the eyebrow in the direction of hair growth (fig. 17).
IMPORTANT: Do not use the Groomer to define or trim the entire eyebrow. Do not try to trim your eyelashes. Be careful not to get too close to your eyelashes and eyes!
3Turn off Groomer. Rinse attachment clean after each use.
