XP SBC HC
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.
Problem | Remedy | |
|
|
|
No sound | – Check if the AC/DC adapter is fully inserted into the | |
| AC outlet and that its DC connector is properly inserted | |
| into the 12 Volt DC input connector located at the rear | |
| of the transmitter. | |
| – Check if the headphone’s on/off switch is in the on | |
| position. | |
| – Headphone batteries running low. Position the | |
| headphone on the transmitter and contact. (See | |
| Headphone power supply) | |
| – Check if the audio source is switched on and tuned to | |
| a channel with audio. | |
| – Volume not adjusted. Adjust the volume on the audio | |
| source/ headphone to a higher level. | |
| – Adjust the headphone’s tuning frequency. Press and | |
| hold the tuning control button for about 1 second. | |
| – Make use of the HC8652 transmitter. Some | |
| transmitters already built into other equipment may not | |
| be compatible with the HC8655 headphone because of | |
| the advanced technologies used in the HC8655 | |
| headphone. | |
|
|
|
Distorted sound | – Adjust the headphone’s tuning frequency. Press and hold | |
| the tuning control button for about 1 second. Repeat if | |
| necessary until the red tuning indication lights up. | |
| – Adjust the transmitter’s frequency. Select any of the | |
| 3 channels of the transmitter. Next adjust the | |
| headphone’s frequency by pressing and holding the | |
| tuning button for about 1 second. | |
| – Headphone batteries running low. Position the | |
| headphone on the transmitter and contact. (See | |
| Headphone power supply) | |
English
9
