12Preparing the remote control foroperation
The remote control and its batteries are packed separatelyin the
original DVD recorder packaging. You must install the batteries in the
remote control before use - described in the following section.
1Take the remote control and the enclosed batteries(2 batteries).
2Open the battery compartment, insert the batteriesas shown and
then close the battery compartment.Match the polarities (+ and -)
on the batteries with the diagram on the remote.
The remote control is now ready to use.
Its range is approximately5 to 10 meters.
'Aim' correctly
Aim the remote control at the DVD recorder and not at the TV set.

Using your DVD<Recorder remote control

with your TV set

With the enclosed multicode remote control you can control the main
functions of your TV set. To do this, you must first enter a code
number that corresponds to the make of your TV set.
You will find a summary of all availableremote control codes on the
last page of this manual.
aMy TV set will not react
bAlso try to enter the other code numbers or that of other
manufacturers.
bIn some cases, it is possible that your TV set will not react to the
selected code numbers. If this is the case,you unfortunately cannot
use this function.
1You can select one of the following functions:
TV VOLUME qincrease the TV volume
TV VOLUME rdecrease the TV volume
For the following functions you need to hold down the •
TV button (on the left side) and then select the function you need
with the appropriate button.
TV/MUTE yswitch off sound
STANDBY mswitch off the TV set
CHANNEL qnext channelr
CHANNEL rprevious channelr
Additionally on Philips TV-sets:
T/C switch Teletext (TXT) on/off
TIMER sClock display on the screen on/off
RETURN To return to the previous menu step
SYSTEM MENU Call up the System Menu from the TV
B,AIn the menus cursor up/down
D,CIn the menus cursor left/right
OK Confirm functions or settings
Color buttons Buttons for special functions
TUNER Switchng the TV from the external jacks to
the internal tuner (TV channels).
Connecting to the antenna
To receive TV programs you have to connect the DVD-recorder to
the antenna or the cable network.
1Switch off your TV set.
2Remove the antenna or cable TV signal from your TV. Insert it into
the ANTENNA IN jack at the back of the DVD Recorder.
3Insert one end of the supplied antenna cable into the TV
OUT jack at the back of the DVD Recorder and the other end
into the antenna input jack at the back of the TV.
The TV's Antenna In jack may be labeled ANT IN, RF IN, 75 ohm,
etc. Check your TV instructions for details.
ENGLISH
Connecting the DVD recorder