18ENGLISH
, During the second phase of the cleaning program, the shaver is placed in the drying position, indicated by a flashing drying symbol. This phase takes approx. 4 hours.The shaver stays in this position until the end of the program.
,After the cleaning program, the battery symbol on the Jet Clean System goes on to indicate that the shaver is being charged.
Note: If you press the on/off button of the Jet Clean System during the cleaning program, the program aborts and resets. In this case, the cleaning or drying symbol stops flashing and the holder returns to its starting position.The shaver may still be wet and dirty, because the cleaning program has not been finished.
Note: If you remove the adapter from the wall socket during the cleaning program, the program aborts.The holder remains in its current position.When you put the adapter back into the wall socket, the holder moves to the highest position.
- When the fluid level drops below the minimum level, the cleaning symbol and the ‘fluid low’ symbol start to flash with intervals and the holder returns to its starting position.
Cleaning the Jet Clean System
Empty the cleaning chamber and clean it thoroughly by rinsing it with hot tap water every 15 days if you use the Jet Clean System daily. Otherwise empty and clean the cleaning chamber at least once a month.
1Clean the outside of the Jet Clean System with a moist cloth.
Downloaded4222.002from.4998www.Manualslib.2.indd .com18 manuals search engine
