Tuner Operations
IMPORTANT!
Make sure the FM and AM antennas are connected.
Tuning to radio stations
A Press SOURCE repeatedly until “FM” appears on the display panel (or press TUNER on the remote control).
B Press and hold / on the remote control until the frequency indication starts to change, then release.
The next radio station will tune automatically.
C To
Presetting radio stations
You can store up to 40 preset radio stations in the memory. There are three different ways to program the radio stations:
–Using auto install (for first time setup only)
–Using automatic preset
–Using manual preset
Helpful Hints:
–If no radio station is found after searching from FM to AM band, “CHECK ANTENNA” appears. Press any keys to exit the tuner preset mode.
–If you attempt to program more than 40 preset radio stations, “PROG FULL” appears.
Using auto install
This feature is only applicable for first time radio station programming. You will be prompted to install the radio stations when you access the tuner mode. With one touch of button, all the available radio stations will be stored automatically.
A Press TUNER.
“AUTO INSTALL PRESS PLAY” appears.
The system will exit auto install mode if no button is pressed within 10 seconds or STOP button is pressed.
B Press N.
“AUTO” appears on the display panel. The system will start searching from
the FM band followed by the AM band. All the available radio stations with strong signal will be stored automatically.
Once complete, the first preset station will be played back.
English
37