Philips ISP1301 manual Contents

Philips SemiconductorsISP1301 USB OTG Transceiver Eval Kit User’s Guide

CONTENTS

1.	INTRODUCTION		5
2.	SYSTEM REQUIREMENTS		5
3.	CONFIGURATIONS AND SETTINGS		6
3.1.	POWER REQUIREMENTS		6
3.2.	I2C MASTER SELECTION		6
3.3.	USB INTERFACE		7
3.4.	AUDIO INTERFACE		7
3.5.	RESET		7
4.	LOCATION OF MAJOR COMPONENTS		7
5.	TEST PROGRAM 1301.EXE		8
5.1.	INTRODUCTION		8
5.2. RUNNING THE TEST PROGRAM			9
5.3.	USING MENUS		9
5.3.1. Choose I2C slave address for ISP1301			9
5.3.2.		Reset all registers	9
5.3.3.		List all registers	10
5.3.4.		Read/Write register	10
5.3.5. Select Mode of Operation			11
5.3.6.		Enable/Disable charge-pump	11
6.	HARDWARE DESCRIPTION		12
6.1.	BLOCK DIAGRAM		12
6.2.	FUNCTIONAL DESCRIPTION		12
6.2.1.		PCF8584 I2C-bus controller	12
6.2.2. PC parallel to I2C converter			12
6.2.3. HC, DC and OTG core logic interface connector			12
6.2.4.		Power manager	13
6.2.5.		Audio interface	13
7.	CONNECTOR PIN INFORMATION		13
7.1. DB-25 PC PARALLEL PORT CONNECTOR (J10) PIN ASSIGNMENT			13
7.2. 8-BIT MICROPROCESSOR INTERFACE 20 X 2 HEADER (J13) PIN ASSIGNMENT			13
7.3. USB OTG CONTROLLER INTERFACE 8 X 2 HEADER (J8 AND J3) PIN ASSIGNMENT			13
8.	SCHEMATICS OF THE EVALUATION BOARD		14
9.	BILL OF MATERIALS		17
10.	REFERENCES		18

UM10028_1		© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
User’s Guide	Rev. 1.0—February 2003	3 of 18