![](/images/new-backgrounds/1030246/3024629x1.webp)
LTC 2600 Series | Section 2 Installation |
|
|
12.Return to the Quick Setup main menu by pressing the zoom key. Continue by selecting VCR Setup (menu shown below).
VCR SETUP SETUP 1
>RECORD SETUP *VCR OUT*
PLAYBACK FORMAT | LTC2600 |
RECORD LOCK | OFF |
Choose:SELECT More:V Exit:ZOOM
Standard Model Display.
VCR SETUP SETUP 1
>RECORD SETUP *VCR OUT* RECORD SETUP *MON B*
PLAYBACK FORMAT | LTC2600 |
RECORD FORMAT | LTC2600 |
RECORD LOCK | OFF |
Choose:SELECT | More:V |
Exit:ZOOM
LTC 2672 and LTC 2682 Series Display
(System4 Duplex) only.
NOTE: The LTC 2600 Series multiplexers are configured to record and playback from a wide range of VCRs. The VCR provides a pulse (VEXT) each time a video field is recorded to tape. This signal lets the multiplexer know that it can switch to a new camera. This feature also simplifies installation by synchronizing the normal and alarm recording speeds. You will need to decide how you are going to synchronize the multiplexer and the VCR. The options are:
(a)Connect and enable the VEXT output from the VCR and then choose the recording speed of the VCR. This is the simplest and recommended method of synchronizing the multiplexer to the VCR. (Follow steps
(b)If VEXT is not available, specify the VCR model and time lapse mode. Begin at step 15 (skip
13.Connect the VEXT output from the VCR (CAM SW Out or Record Out) to Pin 21 (White/Black/Red) and Ground to Pin 25 (White/Black/Blue) of the Alarm In/Out (cable supplied).
14.From the VCR Setup menu, select RECORD SETUP, then move to the VEXT INPUT selection. Switch it to the ON setting (the factory default is OFF).
RECORD SETUP *VCR OUT* SETUP 1
>VEXT INPUTOFF SELECT VCR
TIME LAPSE
Choose:SELECT More:V
Exit:ZOOM
15.The alternate method for synchronization of the multiplexer and the VCR requires (a) selecting the appropriate VCR model, and then (b) selecting the identical setting in the VCR
15