E n g l i s h
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.
Problem
No power.
No picture.
Distorted or poor picture.
Completely distorted picture or black/ white picture.
The aspect ratio of the screen cannot be changed even though you have set the TV display.
No sound or distorted sound.
The DVD system does not work.
Solution
–Check if the AC power cord is properly connected.
–Press the STANDBY ON on the front of the DVD system to turn on the power.
–Refer to your TV’s manual for correct Video In channel selection. Change the TV channel until you see the DVD screen.
–Press DISC on the remote.
–Check the video connection. If both
–Sometimes a small amount of picture distortion may appear. This is not a malfunction.
–Clean the disc.
–TVs have a colour system standard. If the disc’s or DVD system’s colour system is different than your TV’s colour system, the picture may be distorted or colourless. Set to the correct ‘TV System’ setting.
–The aspect ratio is fixed on the DVD disc.
–Depending on the TV, it may not be possible to change the aspect ratio.
–Adjust the volume.
–Replace the speaker cables.
–Check the speaker connections and settings.
–Disconnect the headphones.
–Press PLAY to resume normal play mode if necessary.
–Press the correct source button on the remote (TV or AUX, for example) to choose the equipment that you want to hear through the DVD system.
–Disconnect the power cord from the power outlet for a few minutes. Reconnect the power cord and try to operate again as usual.
38
38 | 3139 115 22612 | |
21/08/2003, 9:44 AM |
