EN
•Insert UHF
•Attach Reflector Arm Mounting Brackets to assembled UHF Boom (previous step) using two
•Attach Corner Reflector Arms to Reflector Arm Mounting Brackets by sliding Reflector Arms between Mounting Brackets. Secure with
Assembly of VHF Portion
• Rotate reflector element rods on VHF
• Attach one 46˝ Element to hole A in VHF
• Attach one 50˝ Element to VHF
Repeat each steps with second boom for VHF
EN
•Insert VHF
•Attach tubing brace to rear of VHF Boom with
•Slide UHF Boom through center slot of VHF Boom support block until hole A of UHF Boom aligns with hole B of VHF Boom. Secure with
•Attach phasing wire and
•Insert end caps at ends of all booms.
Mast Assembly (Mast not included)
• Assemble
• Use saddle on center of boom.
• Assemble
• Insert mast through
• Tighten
•Attach mast standoff to mast.
•Insert wire in standoff and tighten with pliers.
•Power lines should be as far away as possible.
•Assemble
•Secure mounts to wall with wood screws.
•Separate mounts by at least two feet.
•Insert mast with assembled antenna through both
•Face antenna toward TV station.
•Tighten
•Wall mounts and chimney mounts are not included.
6 | 7 |