CD Operation

Disc Playback

a disc is loaded in the disc tray

the current selected disc tray is empty the current selected disc tray is loaded the disc tray is currently playing

To play all discs on the disc tray

●Press PLAYÉ(ÉÅ).

➜All the available discs will play once, then stop.

➜During playback, the selected disc tray, track number and elapsed playing time of the current track will appear on the display.

To play one disc only

●Press one of the CD DIRECT 1/2/3 buttons on the remote control.

➜ The selected disc will play once, then stop.

To interrupt playback

●Press PAUSEÅ(ÉÅ).

➜The current track time flashing.

●To resume playback, press PLAYÉ(ÉÅ) again.

To stop playback

●Press Ç.

To search for a particular passage during playback

●Press and hold à or á and release it when the desired passage is located.

➜During searching, the volume will be reduced.

To select a desired track

●Press í or ë repeatedly until the desired track appears on the display.

●If playback is stopped, press PLAYÉ(ÉÅ) to start playback.

Note:

– In Shuffle mode, pressingí will cause the player to skip only to the beginning of the current track.

To skip to the beginning of the current track during playback

●Press í once.

To resume playback from the last selected track

●In CD stop or pause mode, press CD RESUME on the remote control to start playback again from where you have stopped.

Notes:

–Resume will not be available if you have changed the disc, opened the disc tray or disconnected the system power supply.

–Select CD RESUME in any other source mode will only able to resume the last selected CD active mode (for example, CD stop or playback).

To replace disc during playback

You are able to replace or load in disc into the other two disc trays without interrupting current playback.

●While playback, press the CD OPEN•CLOSE button of the inactive disc trays (refer to “Loading Disc”).

●If you press CD OPEN•CLOSE button of the active disc tray, the disc will stop playing and the disc tray will slide out.

➜ Once the disc tray is opened, it will be deselected.

Programming the disc tracks

Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order.

1Load the desired discs on the disc trays (refer to “Loading Disc”).

2Press PROG to start programming. ➜ PROGRAM will start flashing.

3Press CD 1•2•3 or CD DIRECT 1/2/3 button to select a disc.

4Press í or ë repeatedly to select the desired track.

5Press PROG to store the track.

Repeat steps 3–5to store other discs and tracks.

6 Press PLAYÉ(ÉÅ) to start program playback.

➜"PLAY PROGRAM" will be displayed.

●To end programming without starting playback, press Çonce .

➜ The total number of tracks programmed and the total playing time will appear on the display.

English

17

pg 001-030/C50-C70/37-Eng

17

3/7/01, 3:48 PM

3139 115 20751