Philips MC-45 Timer Setting, TAPE, TIMER, TUNER, TIMER, TIMER, SNOOZE, SNOOZE, English, IMPORTANT, two seconds, TIMER ON/OFF, To check the TIMER

Clock/Timer

Timer Setting

The system can switch on to CD,TUNER, or TAPE mode automatically at a preset time, serving as an alarm to wake you up.

IMPORTANT!

–Before setting the timer, ensure that the clock is set correctly.

–The timer will always be switched on after it has been set.

–The timer will not start if a recording is in progress.

–The volume of the timer will increase gradually from the minimum level to the last tuned volume level.

1Press and hold TIMER on the remote control for more than two seconds.

➜ "AM 12:00" or "00:00" or the last timer setting will start flashing.

➜ TIMER will start flashing.

➜ The selected source will be lighted while other available sources are flashing.

2Press CD 1•2•3, TUNER or TAPE to select the desired source.

●Before setting the timer, make sure the music source has been prepared.

CD 1•2•3 – Load the disc(s).To start from a specific track, make a program (refer to “CD Operation - Programming the disc tracks”).

TUNER – tune to the desired radio station.

TAPE – load a prerecorded tape.

3Press à or á repeatedly to set the hour for the timer to start.

4Press í or ë repeatedly to set the minute for the timer to start.

5Press TIMER to store the start time.

➜"TIMER ON" will be displayed and followed by the set timer "XX:XX" and then the selected source.

➜TIMER will remain on the display.

●At the preset time, the selected source will play.

To exit without storing the setting

●Press Çon the system.

Notes:

–If CD is the selected source and it is not available when the preset time is reached,Tuner will be selected automatically.

–During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.

To check the TIMER

●Press TIMER on the remote control.

➜If the timer has been activated, the set timer information will be displayed.

➜If the timer has been deactivated, "OFF" will be displayed.

To activate/deactivate the TIMER

●Press TIMER ON/OFF repeatedly on the remote control.

➜If activated, the last set timer information will

be shown for a few seconds and TIMER will appear on the display.

➜If deactivated, “OFF” will be displayed.

To deactivate the wake up timer (five minutes interval)

●After timer wake up, press SNOOZE on the remote control.

➜ The system will switch to standby mode for five minutes. After that, it resumes the timer last selected source again.

●To cancel the snooze function, press SNOOZE again.

Note:

– You are only able to activate the Snooze function within 30 minutes after timer wake up.

English

25

pg 001-030/C50-C70/37-Eng 25 3/7/01, 3:48 PM 3139 115 20751