|
| Clock/Timer | ||
|
|
|
| English |
| 5 | T H E A T H R E |
|
|
PRESET | TUNING |
|
|
|
|
| ANGLE | MODE PROGRAM | |
|
| IS | DSC |
|
Clock setting
See
Timer setting
●The system can be used as an alarm clock, whereby the last selected source is switched on at a set time (one time operation).The clock time needs to be set first before the timer can be used.
1In standby mode, press and hold TIMER on the remote for more than three seconds.
➜ "SET TIMER" is displayed briefly.Then, the hour digits flash on the display panel.
2Turn the VOLUME control on the front panel or press VOL +/- on the remote to set the hours and press TIMER on the remote to confirm.
➜ The minute digits flash on the display panel.
3Turn the VOLUME control on the front panel or press VOL +/- on the remote to set the minutes and press TIMER on the remote to confirm.
➜ "ON" or "OFF" flashes.
4Turn the VOLUME control on the front panel or press VOL +/- on the remote to activate or deactivate the timer and press TIMER on the remote to complete the setting.
➜ Display shows 
if activated, and disappears if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off by itself after a set period of time.
1Press SLEEP on the remote control repeatedly to select a preset time.
➜The selections are as follows (time in minutes):
0FF™010 ™ 020 ™ 030 ™ 040 ™ 050 ™ 060 ™070 ™ 080 ™ 090™ 0FF
➜"SLEEP XX" is displayed. "XX" is the time in minutes.
2When you reach the desired length of time, stop pressing the SLEEP button.
To deactivate the sleep timer
●Press SLEEP repeatedly until "0FF" is displayed, or press ECO POWER/STANDBY ON y.
37
