Philips MDV530VR owner manual Disc Playback, Press OPEN/CLOSE a, On the DVD/VCR, 4Insert a Disc

Before you begin, turn on the TV, Stereo, and other equipment connected to the DVD/VCR. Make sure the TV and the Stereo (if applicable) are set to the correct channel.

Details are on pages 7-15.

1 Press STANDBY-ON to turn on the DVD/VCR.

2 Press DVD so the red DVD light appears on the front of the DVD/VCR.

3 Press OPEN/CLOSE A (to the right of the disc tray on the front of the DVD/VCR) to open the Disc tray.

4 Place a Disc into the tray. If the DVD is recorded on only one side, place the Disc in the tray with the label fac- ing up and the shiny side facing down. Some DVDs are recorded on both sides. Make sure the label of the side you want to play is facing up.

5 Press PLAY B. The tray will close and play will begin at the first Chapter or Track. If a DVD menu appears instead, see page 48. With some Audio CDs, playback will not begin unless you press PLAY B.

Or, press OPEN/CLOSE A or press the tray toward the DVD/VCR to close the tray.

With MP3 and JPEG files, playback will begin from Track 1.

6 Press STOP C to stop playback.

Remember, this DVD/VCR will play only certain Discs.

See page six for details.

Disc Playback 19

			STANDBY-ON	1
	TIMER SET
	SETUP	AUDIO SUBTITLE	ANGLE
	REC	REPEAT	REPEAT
			A-B
		C-RESET
2	SKIP/	CLEAR	SKIP/
	CH		CH
	TITLE	MODE	RETURN
		DISPLAY
	DVD		VCR
	DISC
	MENU		OK
6	STOP		PLAY	5
	REW		FF

PAUSE

3 Press OPEN/CLOSE A

on the DVD/VCR.

4Insert a Disc.

Helpful Hints

•An “X” may appear at the top right corner of the TV screen when you try a feature. Either the feature is not available on the Disc, or the DVD/VCR cannot access the feature at this time. This does not indicate a problem with the DVD/VCR.

•If a Disc is dirty or scratched, the picture may appear distorted or playback may stop. Remove the Disc and turn off the DVD/VCR. Disconnect the power cord, then reconnect it. Clean the Disc, then turn on the DVD/VCR again and reinsert the Disc for playback.

•When the DVD or CD light appears on the display panel, the Disc is loaded and ready for playback.

•When you press OPEN/CLOSE A or PLAY (DVD) on the front of the DVD/VCR when the power is off, the DVD/VCR will turn on in DVD mode. Otherwise, the DVD/VCR will turn on in the mode in which it was turned off.