Philips MX5500D Connections, E n g l i s h, Using S-Videojack, Set the P-SCAN switch to ‘OFF.’

Connections

		COMPONENT
	S-VIDEO	VIDEO IN
AUDIO	IN	Pr/Cr
OUT
		Pb/Cb
	VIDEO IN
		Y
		1

E n g l i s h

RF coaxial cable to TV

2

Back of RF Modulator

(example only)

INT IN	TO TV VIDEO	AUDIO IN
	IN	R	L

CH3 CH4

FRONT	L			AM
	R				FM ANTENNA
CENTER
	C			AUDIO		VIDEO
		DIGITAL	AUX	TV	LINE	OUT
SURROUND	SL					Pr
		OUT	IN	IN	OUT	CVBS
	SR		L			Pb
WOOFER	SUB		R				P-SCAN
						Y	ON OFF
		DIGITAL				S-VIDEO
		IN

23

Antenna or

Cable TV Signal

	CENTER FRONT	L
SYSTEMS		R
		C
SPEAKER	SURROUND	SL
		SR
SUB-	WOOFER	SUB

		AM
			FM ANTENNA
		AUDIO		VIDEO
DIGITAL	AUX	TV	LINE	OUT	Pr
OUT	IN	IN	OUT	CVBS
	L				Pb
	R					P-SCAN
					Y	ON OFF
DIGITAL				S-VIDEO
IN

1 3

IMPORTANT!

–If the picture is distorted, check the Video Output setting. Make sure it is set to ‘S-Video,’ see page 32.

Using S-Video jack

1Use the S-video cable (not supplied) to connect the DVD system’s S-VIDEO OUT jack to the S-Video input jack (or labeled as Y/C or S-VHS) on the TV.

2To hear the TV channels through this DVD system, use the audio cables (white/red) to connect TV IN (L/R) jacks to the corresponding AUDIO OUT jacks on the TV.

3 Set the P-SCANswitch to ‘OFF.’

IMPORTANT!

–If your TV only has a single Antenna In jack (or labeled as 75 ohm or RF In,) you will need an RF modulator in order to view the DVD playback on the TV. See your electronics retailer or contact Philips for details on RF modulator availability and operations.

Using an accessory RF modulator

1Use the composite video cable (yellow) to connect the DVD system’s CVBS jack to the video input jack on the RF modulator.

2Use the RF coaxial cable (not supplied) to connect the RF modulator to your TV’s RF jack.

3 Set the P-SCANswitch to ‘OFF.’

13