Internet and PC Link

English

C) Wired home network with a router

Follow these instructions if you have a home network with a router and broadband Internet access.

broadband internet

router

1Connect ETHERNET on the Streamium System to a LAN port of your router with the supplied ethernet cable.

2Press INTERNET on the remote control.

If the Streamium System connects to the Internet you will be asked to register with “My.Philips.com.” Continue with chapter “Registration.”

If the Streamium System does not connect to the Internet

The Streamium System may not connect to the Internet because

–a connection error has occurred. Press INTERNET again to reconnect.

–the router is not connected to the Internet. Check if the computers connected to the router have access to the Internet.

–the IP settings are not correct. Continue with “If ‘An IP address could not be obtained automatically.Would you like to enter your network settings manually?’ appears.”

–your Internet service provider is using a proxy. Continue with “If ‘The system could not connect to the server.’ appears.”

If ‘An IP address could not be obtained

automatically.Would you like to enter your

network settings manually?’ appears

1Press the red button (SUBTITLE) on the remote control to connect again to the Internet automatically. Always try this solution first. If necessary, repeat this step several times.

2If the Streamium System connects to the Internet, continue with chapter “Registration.”

If the Streamium System does not connect to the Internet, press the green button (ANGLE) on the remote control to enter the IP settings manually. Please contact your Internet service provider to get all the information you need below.

Next, you will be asked to enter

–the IP address for the Streamium System

–the netmask: Make sure all computers in your network, as well as the Streamium System, have the same netmask. If you are not sure, try 255.255.255.0.

–Default Gateway:The IP address of your router

–two DNS.

Use the number buttons on the remote control to enter each setting and press 2OK to confirm each setting.

If ‘The system could not connect to the server.’

appears

Maybe the system does not connect to the Internet because your Internet service provider uses a proxy.You need to enter the proxy name and proxy port. Please contact your Internet service provider to get this information.

1Press the green button (ANGLE) on the remote control if your Internet service provider uses a proxy.

2Use the number buttons to enter the proxy name. Next, press 2OK.

3Use the number buttons to enter the proxy port. Next, press 2OK.

➜ The Streamium System tries to connect to the Internet.

PC LINK connection

●After the Streamium System has connected successfully to the Internet, press PC LINK to connect to the PCs in your network.

The Streamium System may not connect to the PC because

–a connection error has occurred. Press PC LINK again.

–you have not yet installed the Philips Media Manager software on your PC.

–the PC is switched off.

24 Please visit http://My.Philips.com