Philips MZ3 manual General Information, Power Supply

GENERAL INFORMATION

CAUTION

Use of controls or adjustments or performance of pro- cedures other than herein may result in hazardous radiation exposure

POWER SUPPLY

21

English

Supplied accessories

-2 speaker boxes

-remote control with batteries

-AM (MW) frame aerial

-FM aerial wire

General maintenance

•Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.

•To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.

Batteries for the remote control

•Open the battery compartment and insert two batteries, type AA, R06 or UM3 (preferably alkaline) with the correct polarity as indicated by the + and – symbols inside the compartment.

Important! Remove the batteries if they are exhausted or if the unit is not to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

Speaker connections

The speaker terminals are click-fit connectors. Use them as shown below.

–Connect the unmarked wire to the red terminal and the marked black wire to the black terminal.

• When headphones are inserted into the headphone socket the speakers are disconnected.

AUX in
8 Ω	speakers
LEFT	LEFT
–	+

RIGHT	RIGHT
–	+

Power supply

1Check if the mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local mains voltage. If it does not, consult your dealer or service centre.

2If your set is equipped with a voltage selector on the bottom of the set, adjust the selector so that it matches with the local mains.

3Connect the mains plug to the wall socket and the set is

now ready for use.

™ The clock display … : … flashes.

4To disconnect the set from the mains completely, remove the plug from the wall socket.

For users in the UK, please follow the instructions on page 2.

POWER-SAVING AUTOMATIC STANDBY

As a power-saving feature, the unit automatically switches to standby if:

•15 minutes after a CD has reached the end and no control is operated.

•after more than 24 hours no controls are operated

Safety information

•Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating.

•The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated.

This set complies with the radio interference requirements of the EU.

5