#Press r to exit memo recorder mode.
Note:
To change your outgoing message, simply record over the previous one by proceeding as described above.
Setting the day and time
You need to enter the day and time so that your memo recorder can time stamp the messages you receive. When you enter memo recorder mode or when you listen to your messages, the day and time are displayed.
In the event of a power failure, this operation must be repeated.
Default setting: MON 00:00.
Press R, press
Press - or + until you reach '$< 7,0(, then press o.
!Press - or + to select a day of the week, then press o to confirm.
"Press - or + to select the hour, then press o to confirm.
#Press - or + to select the minutes, then press o to confirm.
$Press R to exit menu mode.
Note:
When you switch the unit on again after a power failure, the default day and time are: MON 00:00. After a power failure, the red light on the base station flashes quickly to indicate that the time setting has been erased.
Using your memo recorder
When you have installed your Oniso and set up the memo recorder (day and time set), the memo recorder is ready for use.
Switching on the memo recorder
Press r to enter memo recorder mode then, if message playback starts, press s.
l is displayed. The number of messages and the time are displayed.
Your Onis Memo recorder | 13 |