| CD |
|
|
English | Playing a CD |
1 Press PLAYĥto start playback. | |
| ª The disc tray, track number and |
| elapsed playing time of the current |
| track appear on the display. |
•To interrupt playback, press PAUSEƒ•.
ª The playing time flashes.
•To resume playback, press PLAYƒ• again.
2To stop playback, press ‚.
Notes:
–All the available discs will play once, then stop.
–When the CD has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed.
18
Disc Change
You can change the outer two discs while the third inner disc is stopped or is playing.
1Press DISC CHANGE.
ª The CD carousel tray slides out.
2Replace the discs in the left and right disc trays.
•If you wish to change the inner disc during playback, press DISC CHANGE again.
ª"DISC CHANGE" will be displayed.
ªThe CD will stop playing.
ªThe CD carousel tray will close to
retrieve the inner CD and then open again with the inner CD accessible.
3Press OPEN•CLOSE to close the CD carousel tray.
Selecting a desired track
Selecting a desired track when playback is stopped
1Press ’or ‘(or Digit
2Press PLAYĥ to start playback.
ªThe selected track number and elapsed playing time appear on the display.
Selecting a desired track during playback
•Press ’or ‘(or Digit
ªThe selected track number and elapsed playing time appear on the display.
•If you press ’once it will skip to the beginning of the current track and play the track again.
Note:
–Pressing’during shuffling can only skip to the beginning of the current track.
Searching for a particular passage during playback
•Press and hold ˆor ‡until the desired passage is located.
ª The volume will be reduced.
•Play returns to normal when ˆor ‡ is released.
Programming Tracks
Programming tracks of a loaded CD is possible when playback is stopped. The display will indicate the total tracks stored in the program. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show “PROGRAM FULL”.
1Load the desired discs in the disc trays.
2Press PROG to start programming.
ªThe PROGRAM starts flashing.
ªIt will cancel any previously selected repeat mode.
3Press the CD (CD 1•2•3) or DISC 1/2/3 button to select the disc.
4Press ’or ‘(or Digit
5Press PROG to store the track.
•Repeat steps 3 to 5 to store other discs and tracks.
6Press ‚once to end programming.
ªThe total number of tracks programmed and total playing time appear on the display.
Notes:
–If the total playing time is more than
“99:59“ or if one of the programmed tracks has a number greater than 30, then
pg | 18 | 3/6/00, 1:26 PM | 3139 116 19721 |
