Philips PCA102CD, PCA82CR user manual Setting Master and Slave Jumpers, Slave Mode Master Mode

PHILIPS CD-ROM DRIVE USER’S MANUAL

A.2 Setting Master and Slave

Jumpers

Whether your PC system regards your CD-ROM drive as a master device or a slave device depends on which of the “￿￿” (master) and “￿￿” (slave) jumpers on the back of the drive is capped.

or

Slave Mode Master Mode

Figure A-3 Jumper Settings of Slave Mode and Master Mode

Your CD-ROM drive is shipped with the “￿￿” jumper capped, In spite of this, note from Figure A-3 that capping the “￿￿” jumper is optional for Slave mode.

To set your CD-ROM drive as a master device, simply remove the cap from the “￿￿” jumper and place it over the “￿￿” jumper.

Note: 1. The “MA” and “SL” jumpers cannot be both capped at the same time.

2.A system halt will occur if the “MA” or “SL” jumper is set in conflict with the other device connected to the same IDE port. An IDE port cannot contain two master devices or two slave devices at any moment of time.

24 A