EN |
| Programming Additional Units |
|
|
|
Programming Additional Extension Units
If you would like to add extension units to your current setup, or the indicator light on the extension unit remains red after following the proper installation procedure, you must program the new extension unit to function with the other units. To do so, follow these steps.
1.Press and release the button on the bottom right side of the base unit (two phone connectors),which puts the base unit into program mode.The indicator light on the base unit will begin to flash orange.This retains the current link code,and allows newly added extension units to obtain the same link code.
NOTE: The base unit is in program mode only when the indicator light is flashing orange.
NOTE: If you press and hold the button on the base unit and it turns solid red before it begins to flash orange, you need to press and release the button on all extension units.
NOTE: Ensure neither the base or extension unit is plugged into a surge protector, plug strip, extension cord, other A/C power extension device or GFCI protected outlet.
2.Press and release the button on the right side of the added extension unit, or the one with a solid red indicator light.The indicator light on the extension unit will flash red; then turn solid green.
3.If you are adding more than one extension unit, press and release the button on each added extension unit.The indicator light on every extension unit will flash red;then turn solid green. NOTE: If you press and release the button on the extension unit and it does not turn green when the base is in program mode, press and release the button on the
extension unit again.
NOTE: Do not press the button on the extension unit while the light is flashing; wait until the indicator light is not flashing.
NOTE: If you press and release the button on the extension unit when the base unit is not in program mode, the indicator light will flash red for about ten seconds and then turn solid red. If you intend to program the extension unit, place the base unit into program mode and attempt to
10
