Philips RCP7005TP2L owner manual Connecting to the Aerial, Connections to Your TV

Connections

	ips
English	Depending on your TV and other equipment you wish
	to connect, there are various ways you could connect

the recorder. Use only one of the connections described below.

Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.

Caution

–Make sure the Recorder is connected directly to the TV. Tune the TV to the correct video input channel.

–Do not connect the Recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

–Do not connect your Recorder via your VCR. The DVD image could be distorted by the copy protection system.

Connecting to the Aerial

Remove the aerial cable plug from your TV set and insert it into the aerial socket at the back of the recorder. Plug one end of the aerial cable into the TV socket on the recorder and the other end into the aerial input socket on your TV set.

RF coaxial connection

Connect the RF. OUT jack on the Recorder to the aerial input jack on the TV using the 75-ohm Coaxial Cable supplied (R). The RF. OUT jack passes the signal through from the AERIAL jack.

Aerial	Rear of TV
	SCART INPUT
ANTENNA	AUDIO INPUT	VIDEO
INPUT		INPUT
	LR

R

AERIAL

RF.OUT

Rear of Recorder

Component Video connection

Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the Recorder to the correspon- ding input jacks on the TV using an Y Pb Pr cable (C).

Progressive Scan (ColorStream®Pro) connection

If your television is a high-definition or “digital ready” tel- evision, you may take advantage of the recorder’s pro- gressive scan output for the highest video resolution possible. If your TV does not accept the Progressive Scan format, the picture will appear scrambled if you try Progressive Scan on the recorder.

Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the Recorder to the correspon- ding input jacks on the TV using an Y Pb Pr cable (C).

otes

–Set the Progressive to “ON” on the setup menu for progressive signal, see page 24.

–Set the progressive to “Off” by removing any disc from the unit and close the disc tray. Then press STOP and hold it for five seconds before releasing it.

–Progressive scan does not work with the analog video connections or S-VIDEO connection.

Audio (Left/Right) Connection

Connect the left and right AUDIO OUT jacks of the Recorder to the audio left and right IN jacks on the TV using the audio cables (A). Do not connect the Recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

Rear of TV

						SCART INPUT
VIDEO	S-VIDEO	COMPONENT VIDEO INPUT			AUDIO INPUT
INPUT	INPUT
		Y	Pb	Pr	L	R

Connections to Your TV

Make one of the following connections, depending on	S	C	A T
the capabilities of your existing equipment.
When using the COMPONENT VIDEO OUT jacks,
set the VIDEO OUTPUT switch to COMPONENT.
When using the SCART jack, set the VIDEO OUT-
PUT switch to RGB.

SCART connection
Connect the EURO AV1 AUDIO/VIDEO scart jack on
the Recorder to the corresponding in jacks on the TV
using the scart cable (T).
S-Video connection
Connect the S-VIDEO OUT jack on the Recorder to the
S-Video in jack on the TV using the S-Video cable (S).	Rear of Recorder

16