RU 240- page 5
SBC RU 240 | Instructions for use |
BATTERIES
Insert the batteries as indicated in the battery compartment (rear of remote). Only use batteries of type R03, UM4 or AAA. Replace the batteries when required, or at least once a year.
SETTING UP BY CODE ENTRY
Before you set up the Universal Remote Control to operate your equipment, look up the first code for your equipment in the brands list on page 43.
1.Press a device button to select the device you want to operate.
2.Press and hold 1 and 3 at the same time for 3 seconds.
–The indicator LED lights up.
3.Enter the
–The indicator LED blinks twice to indicate successful
–Press buttons on the remote to check that the code works on your equipment. If it does, write down this code inside the remote's battery lid.
–If the equipment does not respond correctly, try the next code from the code list until the equipment works properly.
–If none of the listed codes work, go to Chapter SETTING UP BY AUTOSEARCH
–Repeat steps 1 to 3 for every piece of equipment you want to operate.
SETTING UP BY AUTOSEARCH
Before you start, make sure the equipment is ready to receive
1.Press a device button to select the device.
2.Press and hold 1 and 3 at the same time for 3 seconds.
–The indicator LED lights up.
3.Press Power y to start the search.
–Every time the LED lights, another code is tested. When the right code for your device is found, the equipment switches off, or the VCR stops playing. Immediately proceed with step 4.
4.Press Power y twice to lock the code.
–The indicator LED blinks twice to indicate successful
Notes
–Turn on the equipment again and press the buttons on the Universal Remote Control to see if they are working as expected. Some codes are quite similar.
If your equipment does not respond correctly, repeat steps 1 to 4 to find a better code.
–Maximum search time is 8 minutes for TV, 4 minutes for VCR and 5 minutes for SAT.
English
5
