English
13
0 - 9
TV VCR
1 3
PROG
Instructions for use
3 Make sure the device is switched on.
4 Press and hold keys 1 and 3 simultaneously - for about three seconds- until the green LED lights up. (Release the keys: the green LED should stay on)
5 Enter your
30seconds.
–The green LED flashes twice.
C H E C K
That’s it! Press a few keys to check correct response. If response is not correct, repeat procedure beginning at step 1, using the next
N O T E
-If the LED displays one long flash, the code was not recognised. Please go back to step 1 and repeat the procedure, using the next
-If no key is pressed within 30 seconds, you have to start again at step 1.
-If no correct code is in the list, go to the next paragraph.
You do not know the brand of your equipment/you can not find the right code in the code list » auto search:
1 Press the mode selector key to select the device (TV or VCR) you want to operate.
2 Make sure the device is switched on (if the device is a VCR, please insert a tape and start playback).
3 Press and hold keys 1 and 3 simultaneously
4 Press the power key to start the search. Make sure that you keep the remote control pointed at your equipment.
–Each time the green LED flashes, another code is sent. When the right code is found, the equipment switches off (VCR stops playback). Immediately press the power key to stop the search.
If the green LED flashed again after the equipment switched off, this means you missed the correct code!
If you missed the code, follow the next procedure, starting at step 5. If the LED did not flash again after the equipment switched off, go to step 7.
5 Switch the equipment manually back on.
6 Press
7 Press the power key to lock the correct code in the SBC RU520’s memory.
– The green LED flashes twice.
C H E C K
Switch equipment on manually. Press a few keys to check correct response. If response is not correct, repeat procedure beginning at step 1.
4
