Philips SDV7700K/17 user manual Mast Assembly Mast not included

Assembly

EN

•Insert VHF Boom-B into VHF Boom-A and secure using 1-1/2˝ screw and lock washers. Repeat steps for 2nd boom as well.

•Attach tubing brace to rear of VHF Boom with 1-1/2˝ screws and wing-nuts.

•Slide UHF Boom through center slot of VHF Boom support block until hole A of UHF Boom aligns with hole B of VHF Boom. Secure with 1-1/2˝ screw and wing-nut.

•Attach phasing wire and lead-in wire to UHF antenna using 3/4˝ screws, washers, and wing-nuts.

•Insert end caps at ends of all booms.

Mast Assembly (Mast not included)

•Assemble U-bolts to cross pieces.

•Use saddle on center of boom.

•Assemble U-bolt assemblies loosely to antenna.

•Insert mast through U-bolts.

•Tighten U-bolts securely. All U-bolts should be on one side of mast.

•Attach mast standoff to mast.

•Insert wire in standoff and tighten with pliers.

•Power lines should be as far away as possible.

•Assemble U-bolts in wall mounts with lock washers and nuts.

•Secure mounts to wall with wood screws.

•Separate mounts by at least two feet.

•Insert mast with assembled antenna through both U-bolts.

•Face antenna toward TV station.

•Tighten U-bolts securely.

•Wall mounts and chimney mounts are not included.

7