Automatically setting the remote control
If you cannot find the right code for your brand device,the remote control can automatically search for the
right code.
1Make sure the TV is switched on and select a channel using the original remote control or the keys on
the TV (for example channel 1).
2Keep keys 1and 3 on the SRU 1018 pressed simultaneously for
five seconds,until the indicator light remains lit.
3Press the ykey of the SRU 1018 and keep it pressed.
– The SRU 1018 now starts emitting all known ‘TV off’signals, one by one.
Each time a code is sent,the indicator light flashes.
4When your TV switches off (stand-by),immediately release the ykey of the
SRU 1018 to confirm.
– The SRU 1018 has now found a code that works on your TV.
5Check if you can operate all functions on your TV with the SRU 1018.
• If this is not the case, you can redo the automatic setting.
The SRU 1018 will then search for a code that perhaps works better.
– After the SRU 1018 has run through all the known codes,the search will stop automatically and the
indicator light stops flashing.
– Automatic programming of a TV takes a maximum of 6 minutes.
6ENGLISH