_e set to
work various external devices
such as VCRs, Cable Boxes,
Satellite Receivers, DBS, etc. by
what is called the search method of
remote controlprogramming. If the
"DIRECT ACCESS" code number
method (shown on the previous
page) did not set your remote to
work your accessory device, then
_ollowthe easy steps listed below.
Vote: The Search Method only
works with devices equipped with
channel display indicators or
capability.
Please read steps 1-4 before begin-
ning.
Press the POWER button on
> .
the dewce your are attempting to
program to turn it ON.
Place the TV/VCR/ACC
Mode Switch in the proper posi-
tion.
Press the (A/CH) • RECORD
and the SMART SOUND but-
tons simultaneously and hold them
down.
The device will begin to change
channels after the remote identi-
fies the correct code. When the
channels start to change release the
VCR RECORD and SMART
SOUND buttons. The remote
should be ready to operate the
device. O
This method can take up to
two minutes to perform.
Don't let the device scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search cycle
will have to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4.
Should a channel change still not
occur, the remote will not work the
desired device.
Satellite Receiver
Cable Converter
VCR
Mmm
000
0
33
!