RF OUT

Then, read the section 'Preparation for use' in the chapter 'Installing your video recorder'.

My screen is empty

Many TVs are switched to the programme num- ber for the scart socket by way of a control signal sent through the scart cable.

If the TV does not automatically switch to the scart socket programme number, manually change to the corresponding programme number on your TV (see your TV's operating instructions).

Connecting without a scart cable

Have an aerial cable ready. 1.Switch off your TV. 2.Remove the aerial cable plug from the aerial

input socket of the TV. Insert it into the AERIAL at the back of the video recorder.

3.Insert one end of the sup-

 

 

plied aerial cable into the

TV

AERIAL

RF OUT at the back of the

 

 

video recorder and the

 

 

other end into the aerial

 

 

input socket at the back of

 

 

the TV.

TV

 

 

 

4.Insert AC cable into the

wall socket. 5.Switch on your TV and

select the programme

number used for video playback on your TV. (see your TV’s operating instructions)

6.Start the TV’s channel search manually as if you wanted to save a new TV channel until the next screen appears. (see your TV’s oper- ating instructions)

PLEASE CONNECT AERIAL OR

CABLE TO THE VCR

THEN...

PUSH P+ KEY

OR...

FOR PLAY ONLY-PUSH PLAY

I do not see the message screen

Check the cable connections.

Repeat the channel search on your TV.

7.Save this programme number setting on your TV for video recorder operation.

Then, read the section 'Preparation for use' in the chapter 'Installing your video recorder'.

Programme number for video recorder operation You have now saved a programme number for use by your video recorder as you would a reg- ular TV channel. This programme number must now be used in future for video recorder play- back ('video recorder' TV channel).

5

EN

 

Page 5
Image 5
Philips VR150/07 specifications Connecting without a scart cable, My screen is empty, Do not see the message screen