Searching for tape position without picture (forward wind and rewind)
1.Stop the tape with L C .
2.Press |
| (reverse) or |
| B 1 | (forward). | ||
s 0 |
| ||||||
3.To stop the tape, press |
|
|
| . |
| ||
| L C | ||||||
|
|
| |||||
Automatic search for a tape position (index search)
Every time a tape is recorded an index marking is written on the tape.
These marked positions can be found again quickly and easily later.
1.To search for the previous marking, press INDEX 3 and then s 0 .
2.For the next marking, press INDEX 3 and then B 1 .
3.As soon as the video recorder finds this marking, it automatically switches to playback.
Manual Tracking
To manually adjust the tracking during playback
and slow motion playback, press PROGRAMME+
PROGRAMME- or P+ 
Tracking will return to Automatic Tracking Adjustment when you press L C , insert a tape, or press K B .
To remove vertical jitter in a Still picture, press PROGRAMME+
PROGRAMME- or P+ 
4. Manual recording
General information
Use 'Manual Recording' to make a spontaneous recording (for example, a programme currently being shown).
If you want to start and stop a recording manually, read the section 'Recording without automatic
If you want to start a recording manually but have it stopped automatically, read the section
'Recording with automatic
Read the section 'Direct record' if you want to record a programme currently being shown. Read the section 'Automatic recording from a satellite receiver', if you want a recording to be controlled automatically by a satellite receiver.
Recording without automatic switch-off
1.Insert a cassette.
2.Use P+ 
P- to select the programme num- ber you want to record, for example, 'P01'.
3.To start recording, press RECORD/OTR I .
4.Stop recording with L C .
Recording with automatic switch-off (OTR One-Touch-Recording)
1.Insert a cassette.
2.Use P+ 
P- to select the programme num- ber you want to record.
3.Press 
.
4.Each time you press 
you will add 30 minutes to the recording time.
Preventing accidental erasing of cassettes
All cassettes (except for rental and store cas- settes) have a security tab on the back of the cassette.
To prevent recording over important recordings (erasing), you can remove this security tab.
If you later decide to record on a protected cas- sette, simply cover the hole with adhesive tape or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows:
1.Find the tape position of the old recording where you want to insert the new recording.
2.Look at the last minute of the old recording (playback).
at the tape position where the
new recording is to go and press 
4.Now start recording as usual by pressing
on the remote control. 5.Stop recording with L C .
9 | EN |
|
