Philips VR960BPH Setting the Controller to Operate a DBS cont’d, 7Wait for a few seconds

Setting the Controller to Operate a DBS (cont’d) 53

6

Press the PLAY 8 or STOP 9 button to set the two-digit code for your DBS (see list below), then press the OK/STATUS button.

SELECT CODE NUMBER OF YOUR DBS RECEIVER

40

7Wait for a few seconds.

CBL / DBS TV VCR

VCR/TV POWER SMARTPICTURE

DID DBS RECEIVER
CHANGE TO CHANNEL 205?
A YES
NO
SELECT: 89	CONFIRM:OK
END: MENU
	DBS CODES
MAGNAVOX DBS		42, 43
RCA DBS		40
SONY DBS		41

	QUICK PROGRAMMING
	1	+	2	+	3
	START	.............	STOP	.............	DATE
	4	-	5	-	6
			DAILY		WEEKLY
	7		8		9
	SPEED		DBS
	ALT		0		CLEAR
		STILL/SLOW
-	....		......		.. +	-
	- ....

76-8

Wait for a few seconds.

•If the DBS changes to channel 205, go to step 8.

•If the DBS doesn’t change to channel 205, press the PLAY 8 or STOP 9 button to select NO, then press the OK/STATUS button. Repeat steps 6-7, using a different code for your brand (if available).

•If the DBS does not respond to any of the codes, press the MENU button to remove the menu. DBS RECEIVER CONTROL IS OFF will appear on the screen briefly.

8

REW FF

PLAY

STOP

VOL OK/STATUS CH

MENU

TIMER

TURBO	AUDIO/	SKIP	REC END
TIMER	MUTE	SEARCH	SEARCH
EJECT			REC /OTR

Press the PLAY 8 or STOP 9 button to select YES, then press the OK/STATUS button. “DBS RECEIVER CONTROL IS ON” will appear for five seconds. “AS A RESULT AUTO CLOCK WILL BE TURNED OFF” may appear on the screen also.

Helpful Hint

• If your DBS does not respond to the code at step 7, the Controller will not change channels at the DBS during a timer recording. In this case, you must select the channel to be recorded at the DBS before a timer recording begins. Enter the DBS output channel (03 or 04) at step 3 on page 40. Leave the DBS on for the timer recording. Details are on page eight.