Plug in the TV and the VCR | Philips VRB413AT, VRB613AT specification

Hookups without a Cable Box/Direct Broadcast System (cont’d) 7

3

Connect the RF coaxial cable (supplied) to the OUT Jack on the back of the VCR and to the ANTENNA IN Jack on the TV. (You may use either a snap-on

type (supplied) or screw-on type of coaxial cable, whichever you prefer.)

Antenna or Cable

	AUDIO		ANT
		L	IN
	OUT	IN
		R
ANT	VIDEO		OUT
	OUT	IN CH3 CH4

AUDIO		IN
L		75V
L		ANT	/
OUT	IN	CABLE
OUT	IN
R
VIDEO		OUT
VIDEO			ANTENNA IN Jack
			ANTENNA IN Jack
OUT	IN CH3 CH4		(on back of TV)
OUT	IN CH3 CH4	RF coaxial cable	example only
		RF coaxial cable

4

Plug in the TV and the VCR.

5

Set the CH3/CH4 switch on the back of the VCR to CH3 or CH4, whichever channel is not used or least used in your area. Set the TV to the same channel. For example, when playing a tape, if the CH3/CH4 switch is set to CH3, the TV should be on channel 03.

	CH	4
	or	3
	CH	3
	CH

CH3 / CH4

Switch

CH3 CH4

			AUDIO		ANT
			L		IN
			OUT	IN
			R
		ANT	VIDEO		OUT
			OUT	IN CH3 CH4
AUDIO
AUDIO		IN
	L	IN
	L
OUT	IN
	R
VIDEO		OUT
VIDEO
OUT	IN CH3	CH4

6

You are ready to turn on the VCR. Please go to page 11 before turning on the VCR.

Image 7

Philips VRB413AT, VRB613AT Hookups without a Cable Box/Direct Broadcast System cont’d, Plug in the TV and the VCR

Contents

VRB413AT VRB613AT Model No Serial No Dear Philips product ownerFor Customer Use This bolt of lightning indi- cates uninsulated material Declaration of Conformity FeaturesSafety Precautions Introduction Table of Contents Before Using Your VCR Disconnect the antenna or cable from your TV Hookups without a Cable Box/Direct Broadcast System Plug in the TV and the VCR Hookups without a Cable Box/Direct Broadcast System cont’d Connections Hookups with a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Recording One Channel/Watching Another Cable Signal Cable Box/DBSTV’s Antenna VRB613 Hookups with a Stereo TVVRB413 Press the Menu button. The display shown below will appear Press the VCR button, then press the Power buttonTurning on Your VCR 2Turn on the TV Press the VCR button Press the Menu button Automatic Channel SetupVRB613 only Adding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button Press the STATUS/EXIT button once or twice to exit Reviewing Memorized Channels Manual Clock Setting Setting the ClockDo each step within 60 seconds of the previous step Enter a 0 before a single-digit number Setting the Clock cont’d Press the VCR button, then press the Menu button Automatic Clock Setting Time Zone Press the VCR button Daylight-Savings Time Language Selection Your VCR remote control may operate your TV. If the remote Setting the Remote to Operate a TV Your code 2Find VCR Button Remote Control ButtonsVOLume o/p Button Press to adjust the volume of your TV Eject Button TV Button Remote Control Buttons cont’dPress to operate the TV If you select Status ON, then select Counter only OFF On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only on VCR Light Timer LightVCR Display Panel Cassette Compartment REWind Button Power ButtonFWD Fast Forward Button Remote Sensor Rear Panel 1Turn on the TV 2Insert a tape in the VCR PlayingVHS Quasi Play Back Sqpb Read and follow the steps below to play a tape RECord light will appear RecordingIf the VCR light appears on the display panel, go to . If VCR light does not appear, press the VCR/TV button once Recording One Channel/Watching Another OTR CH12 One-Touch Recording Daily Timer Recording Time OFF To Correct Push Clear To END Push Exit Timer Recording cont’d Tape Speeds Press the STATUS/EXIT button. Program WAS COM Checking or Cancelling Timer Recordings RF coaxial cable Rerecording Tape Duplication Repeat Play VCR SET UP, then press the F.FWD/B buttonPress the F.FWD/B button so that on appears beside Press the STATUS/EXIT button to see the status display Real-Time Counter Memory Press the VCR button Press the Time Search button Time Search Viewing a Still Picture Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLP Automatic Operation Features Specifically… Understanding On-Screen DisplaysMonitor Press the RECord/OTR button to start recording Multi-Channel Television Sound System VRB613 only cont’d Hi-Fi Stereo Sound System VRB613 only Blue Background Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel 03 or Glossary Specifications Renewed Index Page Page Page Supplied Accessories