Philips VRZ244, VRZ264 Rerecording Tape Duplication, Audio and video cables are not included

VRZ264 4/8/99 7:29 PM Page 41

Rerecording (Tape Duplication) 41

The instructions on this page show you how to copy tapes. The illustration uses two VRZ264 VCRs just like yours. Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow steps 1 - 6. (You may use the AUDIO and VIDEO In jacks on the front of VCR 2 instead if you pre- fer.)

VCR 1

Playing VCR

IN	OUT	ANT.IN
	R
AUDIO
	L
VIDEO		RF OUT
CH3 CH4

1)Use audio cables to connect the AUDIO OUT Jacks on VCR 1 to the AUDIO IN Jacks on VCR 2.

VCR 2	3) Use an RF coaxial cable to connect the RF OUT
Recording VCR	Jack on VCR 2 to the TV’s ANTENNA IN Jack.

IN OUT ANT.IN

R

AUDIO

L

RF OUT

VIDEO

CH3 CH4

audio cables	2) Use a video cable to
	connect the VIDEO OUT
	Jack on VCR 1 to the
video cable	VIDEO IN Jack on VCR 2.

1

VCR 1 will play your tape. Insert a prerecorded tape in VCR

1.If the tape does not have a record tab, playback begins. If this happens, press the STOP/EJECT button on VCR 1 once.

2

VCR 2 will record your tape. Insert a blank tape in VCR 2.

Make sure the VCR power is on and the VCR is in VCR position. (The VCR light will appear on the display panel. If it does not, press the VCR/TV button once.)

3

Turn on the TV; set it to channel 3 or 4, whichever channel the CH3/CH4 switch on VCR 2 is set to.

4

Point the remote control at VCR 2. Press the VCR but- ton, then press the Number buttons 0, 0. L-1 will appear on the display panel.

5

Point the remote control at VCR 2. Press the SPEED but- ton to select SP or SLP.

6

Press the PLAY button on VCR 1 and the REC(ord)/OTR button on VCR 2 at the same time. The \ light will appear

on the VCR 2 display panel.

Helpful Hints

•Unauthorized recording of copyright- ed television programs, video tapes, or other materials may infringe on the rights of copyright owners and violate copyright laws.

•Audio and video cables are not included.

•The VCR in the figure above is the VRZ264. If you have the VRZ244, use a single-plug audio cable to con- nect the AUDIO OUT Jack on VCR

1to the AUDIO IN Jack on VCR 2.

•To stop copying tapes, press the STOP/EJECT button on VCR 2, then press the STOP/EJECT button on VCR 1.

•If you connect the audio and video cables to the AUDIO/VIDEO In jacks on the front of VCR 2, you must select A/V IN FRONT at step

4.To do so, press Number buttons 0,0, then press the CH(annel) 9 button so that A/V IN FRONT appears on-screen and L-F appears on the display panel.