INSTALLATION

POWER SUPPLY AND DEMO MODE

1.Check if the power voltage, shown on the type plate on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.

2.Connect the power plug into the wall outlet. The power supply is now switched on and the display will show the PHILIPS demo mode.

™PH..IL ..IPS scrolls across the display continuously.

•Turn the SET control to SET TIME to exit the demo mode.

3. To disconnect the set completely from the power supply, withdraw the power plug from the wall outlet.

POWER BACK-UP

The power back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 3 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and display illumination will be switched off. As soon as the power supply returns, the display will indicate the correct time.

If power supply returns after 3 minutes and the display shows:

•clock time blinking – indicates you need to re-adjust the clock time

•PHILIPS demo mode – indicates you need to re-enter preset stations and the clock and alarm times.

BASIC FEATURES

ILLUMINATION BRIGHTNESS

1.Check if the SET control is turned to CLOCK position and the radio is switched off.

2.Press REPEAT ALARM/ BRIGHTNESS CONTROL once or more.

–The brightness of the display will change in this sequence:

BRIGHT y MEDIUM y LOW y BRIGHT...

Note:

when an alarm or the SLEEP function is active, brightness cannot be adjusted.

RESET

Should the display and electronic functions of your set receive interference e.g. static electricity from carpets, thunderstorms, etc. RESET allows you to clear all previous settings and start up again.

•Use a ballpoint pen to press the RESET hole found on the bottom of the set.

English

7