6.35 x 0.8 FAST ON
Terminal
4 x Ø 5.3 Holes on Ø 172
Ø 162.5 max.
Ø 117.5 max.
Ø 145.3 max.
68.5 max. 8+
Red dot
Ø 187.5 max.
(on angles)
1060 1070
TYPICAL CHARACTERISTICS
Rated impedance Z 8 16 Ω
Reference efficiency (1 W@1 m) - 97 97 dB SPL
Usable frequency range 1- 300–6000 300–6000 Hz
Power handling capacity 2(AES) - 130 130 W
Max Sound Pressure Level 3SPLmax 114 114 dB SPL
Min. impedance modulus Zmin 6.0 @ 640Hz 12.9 @ 640Hz Ω
Voice-coil inductance 4 @ 1 kHz Le1k 0.58 1.22 mH
@ 10 kHz Le10k 0.23 0.48 mH
Bl product Bl 8.5 11.2 N/A
Moving mass Mms 0.0085 0.0085 Kg
THIELE-SMALL PARAMETERS: TYPICAL (QC LIMITS)
Resonance frequency 5Fs130 (±25) 130 (±25) Hz
DCresistance 6Re5.4 (±0.5) 11.6 (±1.1) Ω
Mechanical quality factor Qms 6.6 6.6 1
Electrical quality factor Qes 0.52 0.50 1
Total quality factor Qts 0.48 0.46 1
Mechanical suspension compliance Cms 180 180 10-6m/N
Effective piston area Sd0.0150 0.0150 m2
Equivalent Casair load Vas 0.0056 0.0056 m3
Max.linear excursion Xmax ±2.0 ±2.0 mm
Linear displacement volume Vd0.030 0.030 10-3m3
Half-space efficiency 2.3 2.3 %
Unity load volume Vas Qts21.3 1.2 10-3 m3
ABSOLUTE MAXIMUM RATINGS
Short term max. input voltage 7Vmax 65 90 V
Max. excursion before damage Xdam 4.0 4.0 mm
Ambient operating temperature –10 to +50 °C
Storage temperature 8–20 to +70 °C
Environmental conditions 9Outdoor
APPLICATION INFORMATION
Air volume occupied by the driver 10 0.46 0.46 10-3 m3
Speaker net mass 2.15 2.15 Kg
Recommended reflex box Vb/Fb3L / sealed L / Hz
Electrical polarity A positive voltage applied on the red
terminal produces forward cone motion.
SPECIFICATION NOTES
Note 1: Allowing for energy response, excursion
capability, Power spectrum, and -3dB low
freq. roll-off for standard reflex tuning.
Note 2: Established at 20°C ambient temp, according to
AES2-1984 standard using IEC268-1 simulated
programme signal and a 3 liter sealed test enclosure
with a 2nd order high-pass filter @ 400Hz.
Note 3: Established at 1m on axis of the loudspeaker mounted
in test enclosure, when driven at full AES Power
Handling Capacity, including 4dB of thermal
compression loss.
Note 4: Measured at 20 mA in free air.
Note 5: Measured at 20 mA and 20°C ambient temp.
in free air conditions, after full run and rest.
Note 6: Measured at 20°C ambient temp.
QC limits are ±10%
Note 7: Stated in RMS voltage according to IEC 268-5.
Note 8: Includes shipping conditions. The lower limit prevents
from demagnetization.
Note 9: Our products are classified in three categories :
Indoor, Outdoor, and Outdoor
✚
for permanent
outdoor use or severe conditions.
Note 10: Calculated for front mounting on to a 18 mm thick
board.
PHYSICAL CHARACTERISTICS
PHL Audio S.A. provides these specifications as representative of current production after conditioning. Because of our continuous research, they are subject to change without notice.