Piega P Sub 4 Settings of the Sound Characteristics

Thanks to the use of the most advanced active electronics, your new P SUB 4 is a cutting edge product in the eld of subwoofers. The

connection and setting options provided on the P SUB 4 allow the best possible connection to your stereo or surround sound system

and can be adapted to your individual audio requirements.

PIEGA P SUB 4

Settings of the Sound Characteristics

>Use this knob to adjust the subwoofer volume

Setting tip: Turn the subwoofer to maximum volume and then turn it

down until it sounds too quiet for you

>The LED is off when the loudspeaker is switched off, and is red when it is in

standby mode. When the subwoofer is in operation the LED is green to indicate

trouble-free operation

>Use this switch to activate the standby function of the P SUB 4.

This enables the subwoofer to switch on automatically as soon as a signal

is received and to switch off when there is no more signal. When the AUTO

POWER switch is in the OFF position, the subwoofer stays permanently

switched on >>Factory setting ON

>Use this knob to set the crossover frequency between subwoofer and full-

range speaker according to the connection method* used.

This will relieve the satellite loudspeakers in the bass range

>>Factory setting 80 – 100 Hz

>Use this switch to set the subwoofer to In Phase or Out of Phase.

Depending on the type of loudspeaker, there will be a phase cancelling

(little bass) or a phase correction (normal bass)

>>Factory setting 0

* LOW PASS is not active when the P SUB 4 is connected to an AV receiver as described on page 8

MIN. MAX.

LEVE

AUTO POWE

AUTO POWER

LOW PAS

PHAS

PHASE

LOW PASS