06Additional information

Specifications

Amplifier section

Power output specification is for when power supply is 230 V.

Continuous power output (both channels driven at 20 Hz to 20 kHz)**

THD 0.2 %, 4 . . . . . . . . . . . . . . . . . 70 W + 70 W THD 0.2 %, 8 . . . . . . . . . . . . . . . . . 55 W + 55 W

DIN Continuous power output (both channels driven at 1 kHz)

THD 0.7 %, 4 . . . . . . . . . . . . . . . . . 73 W + 73 W THD 0.7 %, 8 . . . . . . . . . . . . . . . . . 53 W + 53 W

Total harmonic distortion**

20 Hz to 20 kHz, 25 W, 8 . . . . . . . . . . . . 0.05 %*

*Measured with DIRECT button switched on.

**Measured by Audio Spectrum Analyzer

Audio section

Input (Sensitivity/Impedance)

CD, TAPE, TUNER, AUX . . . . . . . . . 200 mV/47 kPHONO (MM) . . . . . . . . . . . . . . . . . .2.8 mV/47 kPHONO (MC). . . . . . . . . . . . . . . . . . .0.2 mV/100

Frequency response CD, TAPE, TUNER, AUX, USB

. . . . . . . . . . . . . . . . . . . . . . . 5 Hz to 100 kHz dB PHONO (MM) . . . . . . . . 20 Hz to 20 kHz ±0.2 dB PHONO (MC). . . . . . . . . 20 Hz to 20 kHz ±0.3 dB

PHONO (MM) overload level

1 kHz, THD 0.2 %. . . . . . . . . . . . . . . . . . . . . 200 mV

PHONO (MC) overload level

1 kHz, THD 0.2 %. . . . . . . . . . . . . . . . . . . . . . 20 mV

Output (Level/Impedance)

TAPE REC . . . . . . . . . . . . . . . . . . . . . 200 mV/1 k

Tone control

Bass . . . . . . . . . . . . . . . . . . . . . . .± 10 dB (100 Hz) Treble . . . . . . . . . . . . . . . . . . . . . .± 10 dB (10 kHz)

Signal-to-Noise Ratio

CD, TAPE, TUNER, AUX (200 mV input) . .103 dB PHONO (MM, 2.8 mV input) . . . . . . . . . . . . .80 dB PHONO (MC, 0.2 mV input) . . . . . . . . . . . . .70 dB

Signal-to-Noise Ratio (DIN, continuous power/50 mW)

CD, TAPE, TUNER, AUX . . . . . . . . . . 91 dB/65 dB PHONO (MM, 5 mV input) . . . . . . . . 68 dB/60 dB PHONO (MC, 0.2 mV input) . . . . . . . 62 dB/57 dB

Miscellaneous

Power

requirements . . . . . . . .AC 220 – 230 V, 50 / 60 Hz Power consumption . . . . . . . . . . . . . . . . . . 200 W In standby. . . . . . . . . . . . . . . . . . . . . . . . . . 0.6 W Dimensions. . . . 420 mm (W) x 113 mm (H) x 369 mm (D) Weight (without package) . . . . . . . . . . . . . .11.5 kg

Accessories

Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Lithium battery (CR2025) . . . . . . . . . . . . . . . . . . .1 Power cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Operating instructions

Note

Specifications and the design are subject to possible modifications without notice, due to improvements.

Cleaning the unit

Use a polishing cloth or dry cloth to wipe off dust and dirt.

When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers.

Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface.

18

En

Page 18
Image 18
Pioneer A-A9-J manual Additional information Specifications, Cleaning the unit