Installation
DIN Rear-mount
Installation using the screw holes on the side of the unit
•Fastening the unit to the factory radio mounting bracket. (Fig. 15) (Fig. 16) (Fig. 17)
Select a position where the screw holes of the bracket and the screw holes of this product become aligned (are fit- ted), and tighten the screws at 2 places on each side. Use any of binding screws (4 ⋅ 3 mm), binding screws (5
⋅6 mm) or flush surface screws (5 ⋅ 6 mm), depending on the shape of the screw holes in the bracket.
*1 Use binding screws (4 ⋅ 3 mm) only.
*1
*1
Fig. 15
•When installing in a shallow space, use the following screw holes. In this case, stick conceal tape on parts that protrude from the dashboard.
Conceal tape
*1
Fig. 16
Screw
Dashboard or Console
Factory radio mounting bracket *2
*2 If the screw holes of the bracket and the screw holes of this unit are not aligned, use a file to widen the screw holes of the bracket to match up the screw holes on this unit. Tighten the screws at 2 places on each side.
Fig. 17
15
