Section 2 | Installation Instructions |
Connection to Ice Machine (cont.)
VINYL TUBING CONNECTION
1.Insert the tubing into the ½” conduit from the AuCS→ to the ice machine.
2.Slide the 3/8” hose clamp (B) onto the tubing and connect it to the barbed fitting on the AuCS→ dispenser pump.
3/8” HOSE CLAMP (B)
8’ VINYL TUBING
MODULAR WIRE LEAD
SV1643G
Connecting Vinyl Tubing to Dispenser Pump
Using 3/8” Hose Clamp (B)
3.Route the tubing through the bulkhead heyco fitting and into the water compartment.
4.Determine the amount of tubing required and cut off the excess.
5.Slide the 3/8” hose clamp (Part B) onto the tubing and connect it to the water inlet barbed fitting.
AuCS® INLET
WATER INLET
SV1644G
Connecting Vinyl Tubing to
Water Inlet Barbed Fitting
AFTER INSTALLATION
WARNING
Read and understand this entire manual prior to operation of the AuCS→A accessory. You must understand all warning and caution statements and follow all safety precautions to assure proper operation of the AuCS→A accessory.