Manitowoc Ice Q Installation Instructions, Section, General, Electrical Service, Dimensions

Section 2	Installation Instructions
	Section 2
	Installation Instructions

General

These instructions are provided to assist the qualified installer. Check your local yellow pages for the name of the nearest Manitowoc Ice Machine Distributor or call Manitowoc Ice, Inc. for information regarding installation and start-up services.

WARNING

Improper installation will affect dispensing rate. Install only within the parameters outlined in this installation manual.

Please contact your local Manitowoc Distributor or call Manitowoc Ice, Inc. for assistance if you encounter a problem that is not covered by this manual.

3.43"

8.7 CM

12”

30.48 CM

12.12"	9’
30.78 CM
	274.3 CM

8’

243 CM

SV1632G

Dimensions

Electrical Service

WARNING

All wiring must conform to local, state, and national codes.

Voltage/Cycle/	Runnin	N.E.M.A Electrical Plug
Phase	g Amps	Configuration
115/60/1	.3	5-15P
220/240/50/1	.1	No plug attached

115 VOLT WIRING

The 115/60/1 AuCS→ has an eight (8) foot cord which must be plugged into a 15 amp electrical outlet.

CAUTION

Never use an extension cord. If an outlet is not in reach of the AuCS→ power cord, have an outlet installed.

220/240 VOLT WIRING

The 220/240/50/1 AuCS→ can be wired to:

•The terminal block located in the ice machine.

•With a separate plug.

•To a separate disconnect.

TERMINAL BLOCK LOCATED

IN ICE MACHINE

MACHINE	L1		L1
	N		N
TO ICE
WIRED-PRE	GROUND		GROUND
			TO SEPARATE FUSE/
			CIRCUIT BREAKER.
			DISCONNECT ALL POLES.
			REFER TO ICE MACHINE
			INSTALLATION
			INSTRUCTIONS FOR
			FUSE RATING.
			AuCS® POWER
	N	L1	CORD

PRE-WIRED AT AuCS® ACCESSORY

SV1633G

220/240/50/1 Wiring

2-1