Pioneer AVIC-9DVD, AVIC-80DVD Messages and how to react to them, Message When What to do

Messages and how to react to them

The following messages may be displayed by your Navigation System.

❒There are occasions when you may see error messages other than those shown here. In such a case, follow the instructions given on the display.

Message	When	What to do
You cannot use this function while	While trying to make a menu selec-	Pull over and come safely to a halt,
driving.	tion.	put the parking brake on, and then
		try again.
This is not the appropriate disc.	If you try to use a disc which is	Insert a suitable disc.
Please insert the appropriate disc.	incompatible with this system
	(including the old version map disc).
	If you insert a disc upside down.	Insert the disc with the label upward.
	If the disc is dirty.	Clean the disc.
	If the disc is cracked or otherwise	Insert a normal, round disc.
	damaged.
Irregular speed pulse signal is	If the Navigation unit does not	Consult your Pioneer dealer.
detected. Please power off the sys-	receive the vehicle speed pulse.
tem and check the installation. After
you have checked, please re-boot the
system and press “OK”.

Speed pulse wire is not connected. System will start to learn without speed pulse. Please keep in mind that accuracy is not fully ensured without speed pulse.

The speed signal input (pink lead wire) of the power cable is not con- nected.

To operate with 3D hybrid mode, con- nect the speed signal input (pink lead wire) of the power cable cor- rectly. Although it can be operated with Simple hybrid mode without connecting the speed signal input, the precision of the positioning will be less accurate.

Vibration is detected. Please power	While the vehicle is stationary, the	Re-install the navigation unit of the
off the system and check the installa-	Navigation System is installed in a	Navigation System in a place where
tion. After you have checked, please	place where the navigation unit may	the navigation unit will not be
re-boot the system and press “OK”.	be affected by a large vibration.	affected by vibration.
Sensor NG (Vibration)
Direction of G sensor is not correct.	Direction of G sensor is set incor-	See the “Installation Manual” and set
Please power off the system and	rectly.	the direction of G sensor correctly.
check the installation. After you have
checked, please re-boot the system
and press “OK”.
Sensor NG (BAD) angle	The navigation unit is installed with	Confirm the installation angle. (The
	an extreme angle exceeding the limi-	navigation system must be installed
	tation of the installation angle.	within +30 degrees to –15 degrees of
		the horizontal, or within five degrees
		of your vehicle’s direction of travel.)
Gyro Sensor is not working properly.	Abnormal output of Gyrosensor is	Note down the error code shown on
Please consult your dealer or Pioneer	detected.	the screen; turn off the power, and
service center.		then contact your nearest Pioneer
		service facility.
The route could not avoid the speci-	If route setting cannot avoid speci-	Choose whether or not to try setting
fied area.	fied Areas to Avoid.	a route through the area.
Your route could not be found.	Route calculation has failed because	•Change the destination.
	of malfunction of map data, software,	•Clean the disc.
	hardware, or disc.	•Consult the Pioneer Local dealer if
		this message persists.
Route calculation was not possible.	Route calculation has failed because	•Change the destination.
	of malfunction of map data, software,	•Clean the disc.
	hardware, or disc.	•Consult the Pioneer Local dealer if
		this message persists.

Appendix

63