Connecting the System
CAUTION
•Pioneer does not recommend that you install or service your DVD navigation unit yourself. Installing or servicing of the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your navigation unit to authorized Pioneer service personnel.
•Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.
•Do not drill a hole into the engine compartment to connect the yellow lead of the unit to the car battery. Engine vibration may eventually cause the insula- tion to fail at the point where the wire passes from the passenger compart- ment into the engine compartment. Take extra care in securing the wire at this point.
•It is extremely dangerous to allow the GPS antenna lead or microphone lead to become wound around the steering column or shift lever. Be sure to install the unit in such a way that it will not obstruct driving.
•Make sure that wires will not interfere with moving parts of the car, such as the shift lever, parking brake or seat sliding mechanism.
•Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires may become damaged, resulting in a short circuit or malfunction.
•Do not cut the GPS antenna lead to shorten it or use an extension to make it longer. Altering the antenna cable could result in a short circuit or malfunc- tion.
•Do not shorten any leads. If you do, the protection circuit may fail to work properly.
•Never feed power to other electronic products by cutting the insulation of the power supply lead of the DVD navigation unit and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.
5
