After Installing this Product
1. Reconnecting the battery.
First, double-check that all connections are correct and that this product is installed cor-
rectly. Reassemble all vehicle components that you previously removed. Then reconnect
the negative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the RESET button on this product.
Press the RESET button on this product using a pointed object such as the tip of a pen.
4. Enter the following settings:
1 Install the program in the navigation system.
2 Make any necessary installation angle adjustments. (Refer to “Correcting the installation
angle” in the Operation Manual.)
3 Drive until the initialized sensors start operating normally.
4 Set the time and language.
Set the navigation system as explained in the Operation Manual or Hardware Manual.
After installing this product, be sure to check in a safe place, that the vehicle is per-
forming normally.
26
ENG/MASTER 96
Italiano
<CRD4067A/U> 27
CRD4067A_U_inst_001_027_US 10/24/05 19:49 Page 27